Buy the ARP T-Shirt! BIOS Optimization Guide Money Savers!
 
 19 August 2007
 N/A
  N/A
 Guides
 Dr. Adrian Wong
 2.0
 Discuss here !
 130963
 
   
Hands On With The AMD Radeon R9 Fury X, R9 Fury X2 & R9 Nano
AMD not only set up a wide range of sample systems to demonstrate the performance of ... Read here
Desktop Graphics Card Comparison Guide Rev. 31.6
Covering 628 desktop graphics cards, this comprehensive comparison allows you ... Read here
   
Buy The BOG Book Subscribe To The BOG! Latest Money Savers!
DIY Camera Backpack Guide Rev. 2.0
Digg! Reddit!Add to Reddit | Bookmark this article:

Step 1 : Determining The Appropriate Size

The first step would be to determine the appropriate size of the protective sleeve. This depends very much on the depth of the bag as well as the size of the camera and lens.

To find the appropriate size, just wrap some bubble wrap around the lens. This will give you a rough idea of how wide the protective sleeve should be. Please remember to add a little extra space to allow for wider lenses and/or lens hoods.


Wrapping bubble wrap around the lens


Finding the appropriate length

Then, slide the entire ensemble into the bag and see if the bubble wrap fits the bag. If the bubble wrap is too long, fold it until the camera can be seated easily within the bag. If it's too short, then lengthen it. Just remember to leave some extra space to allow for easy closure of the bag.

 

 

Step 2 : Preparing The Cardboard Insert

Once you have used the bubble wrap to determine the appropriate length of the protective sleeve, it's time to prepare the cardboard insert. I use a piece of corrugated cardboard so that the sleeve will be rigid enough to withstand a direct impact without crumpling too much. The cardboard insert will also serve to transmit any direct force to the tough camera body.


Determining the size of the cardboard insert


Resizing the cardboard insert

Using the bubble wrap as a template, find out the appropriate length and width for the cardboard. Make sure it fits comfortably within the folded bubble wrap. Please remember to cut along the corrugations of the cardboard, not perpendicular to them.

Once you are certain about the size of cardboard that you need, cut off the excess portions. After resizing the cardboard insert, try fitting it into the folded bubble wrap. Make sure it fits the bubble wrap. You can cut out excess bubble wrap or you can use the rest to provide additional cushioning.



<<< What Is A Camera Bag?, The Idea, Is It Difficult? : Previous Page   |   Next Page : Creating The Protective Sleeve >>>

 

 
   
How To Always Save Tab Session In Internet Explorer 7?
Can Your Notebook Survive A Good Trashing?
Tech Myths B.U.S.T.E.D. Rev. 1.3
DFI LANParty UT NF4 SLI-DR nForce 4 SLI Motherboard Review
Kingston 15-In-1 Hi-Speed Reader Pictorial Review
Linksys WRT54G Wireless-G Broadband Router Pictorial Review
OCZ EL PC-3200 Gold DDR Memory Overview
Corsair XMS4400 1GB TwinX Memory Kit Review
Micron Rev5B "C" Memory Module Review
512MB Mushkin PC4000 Dual Pack Review

 


Copyright © Tech ARP.com. All rights reserved.